English (UK)Board Care
Lakewakes does not recommend any board manufactured with EPs foam to be stored in bimini pocket board racks. damage may occur to EPs foam boards.
Lakewakes boards are made from EPs foam
CARE FOR INSTUCTION
Lakewakes boards and all Custom Boards made with EPs foam and epoxy will soften in sunlight.
Lakewakes does not recommend the use of board racks of any type , as clamp style racks will leave a in print on all EPs/epoxy Boards. If board rack is used, must adjust rack or bungee cord to fit board, NOT DOING SO MAY DENT BOARD.
Do not leave out in sun unattended, cover up with a towel.
No , platform or deep water starts, no platform dismounts
All Lakewakes boards are SINGLE rider use boards, unless stated on invoice.
Clean board only with glass cleaner.
Remove fins for storage and transportation.
Crumple zone patches located under traction pads to keep premature foot dents from forming, keep feet on traction.
Weight limit of board stated on invoice.
Lakewakes wakesurf boards manufacturer of boards to suit the seasoned rider.
**** Fcs2 fin install video ****
BOARD REPAIRS
All boards made by Mark Werbenec use EPS foam and Epoxy, Only approved surfboard epoxy should be used and repairs to board surface. Google surfboard ding repair kit.
TRACTION PAD REPAIRS
If traction pads material comes loose or unglued from board, a simple repair can be done by using your favorite Super glue GELL type of glue. Make sure pads and board is dry at time of repair.
AIR VENT SYSTEM
As of 6-18-2021 all classic fiberglass construction boards will come with a maintenance free air vent system located at rear of board. We recommend that a fresh water wash after each salt water use is necessary to not clog up the vent system. Keep this area and vent cup free of sand and or dirt for it to work as designed.
Best Regards
Mark Werbenec
